or prefer set back to factory default setting..
Then can use this way to reset back..
1. Connect to the cisco router using hyper terminal..
2. Restart the router..
3. Once see booting, press
Ctrl + break
4. you will access to RONMON
5. In ronmon, type
ronmon 1> confreg 0x2142
6. Hit enter and
ronmon 2> reset
7. Wait the router boot, then press "n" and enter, when asked to enter dialogue wizard.
8. Then start tpe the following command
enable
conf t
config-register 0x2102
exit
write erase
reload
9. That all, you will see the router in factory default setting
Tested on Router 1841.
1 comment:
You are the best. It works.
Post a Comment